Hur6 Hitler

Timeline

Adolf Hitler was born in 1889 in Austria. He then moved to Germany in 1913.  He was decorated during his service in the German army in world war 1. Sometime after 1924 he gained popularity after being released from prison, he attacked the treaty of Versailes and for promoting Pan-Germanism, anti semitism and anti-communism.

 

In November 1932 the Nazi party had the most seats in the German Reichstag. However he didn’t have the majority so no majority party was formed. On the 30th of January 1933 he became chancellor. The enabling act of 1933 turned the Weimar republic into Nazi Germany.

  

Adolf Hitler wanted to eliminate all jews from Germany and make what he called a new order. His first 6 years in power resulted in rapid recovery from the great depression. September 1st 1939 the german army attacked Poland. September 3, 1939 The British and French declared war on Germany. In June 1941 Hitler ordered an invasion of the Soviet Union. By the end of 1941 the Germans had control of most of Europe and North Africa.

 

After 1941 the German army slowly reverted out of these lands. On April 29th he married his lover. On May 1st Hitler and his lover suicided to prevent capture by the Soviet red army. On September 2nd 1945 the allied forces defeated Germany.

Facts Poster

Political Party Poster

How to make a ID tag (Tinkercad Edition)

Hello this is my blog about how to make an ID tag in Tinkercad with screenshots

First, put down a box located on the right

If it's says "hole" change to solid

Change the setting so it looks like this

Your box should look like this

Next, you want to select a cylinder 

Now if your Cylinder doesn't look like the one above you need to change it from solid to hole

Change the sides to max then you should have something like this

Now we need to make the cylinder smaller so select the cylinder then click and hold one of the corners and bring it in 

It should be in the corner now, next move it to the area that you want the hole to be

Now we need to make the hole, press ctrl + a, then press ctrl + g

After some loading, there should be a hole where the cylinder used to be. 

Now you are finished, if you want to add letters and symbol its the same as putting the cylinder on but with what you want